专干老熟女视频久久窝窝手机视频,午夜无码视频免费观看一区,中日国产精品片,加勒比亚洲正在播放

Products

News

How to Glue a JCTC Silicone Rubber Mold

By Lauren Vork, eHow ContributorSilicone rubber is one of the most versatile standard mold-making materials. Flexible yet durable and capable of reproducing high levels of detail, silicone rubber is prized for use in making molds of hard items. Like all rubbers, silicone can rip or break. But if your mold is thick and breaks cleanly into two pieces, you can use a silicone-based glue to restore it, making it as good as new and ready for the next molding project.
1
Clean both of the broken halves of the mold with hand soap and water and dry with a lint-free cloth; this will keep any dust or grit from interfering with the seal or the shape of the repaired mold.
2
Apply a light layer of silicone contact adhesive to each side of the broken mold. Spread the adhesive so that it completely covers the edges of the silicone mold pieces where they were broken or torn. Use a damp rag to wipe away any glue that spreads or leaks onto other areas of the mold.
3
Let the adhesive dry. Read the instructions on the bottle to get the right drying times for the adhesive you're using and follow them to the letter. Different formulas of contact adhesive will have different drying times, and it's important to get the timing just right; too little or too much time will prevent the adhesive from adhering correctly.
4
Line up the halves of the mold to reattach them. Do not let them touch (the glue will bond instantly when you do), but hold them as close as possible without making contact so that you can make sure the edges will line up perfectly.
5
Press the pieces of the mold together. Start with the bottom of the two edges, holding the pieces at an angle so that only the bottoms connect. Line them up as perfectly as possible before pressing them to touch, then slowly roll the two pieces together bottom to tip, watching the edges as you go to make sure they continue to line up. Once the two sides have been pressed together, the glue will bond permanently. Use the mold after the glue manufacturer's recommended wait time for setting.

Search

Search for keywords or models and products.

Contact Us

Jiangsu Tianchen New Material Co., Ltd

Tel: 0511-88135610
0511-88135618
Fax: 0511-88135111
Address: 568 Ganglong Road, Development Zone, Yangzhong City, Jiangsu Province
Email: wangjin@tcgcl.com
主站蜘蛛池模板: 天水市| 莎车县| 松江区| 庆城县| 黑水县| 唐海县| 景德镇市| 礼泉县| 玉环县| 化州市| 孙吴县| 宁津县| 白河县| 巴林左旗| 确山县| 行唐县| 砀山县| 揭东县| 海晏县| 望江县| 盐边县| 六盘水市| 南郑县| 千阳县| 贡觉县| 贵州省| 蒙阴县| 北海市| 贵港市| 西昌市| 宁乡县| 泰兴市| 河北区| 蓬安县| 横峰县| 哈尔滨市| 澎湖县| 盈江县| 永川市| 哈尔滨市| 高雄县|